A217 Gr. WC9 Ball Float Steam Trap Valve Suppliers in india at low price according to international Standard
Lever Ball Float Type Steam Trap allows steam to condense and to circulate into the system as water. It traps the steam so that the steam does not enter the pipelines in the gas state. The trap has a thermostatic air vent that allows the steam into the SS Ball Float Steam Trap, a chamber with a floating ball, an outlet valve and the casing. The air vent is at the top end of the body and the outlet valve is at the bottom of the body. Once the steam enters through the inlet into the chamber, it starts to condense as the ball locks the outlet and there is no water inside the chamber. Once the steam starts to condense, the ball floats in the condensed water.
Stainless Steel Lever ball float steam trap
A217 Gr. WC9 Ball Float Steam Trap Valve
Cast Steel Ball Float Mechanical Steam Trap
ASTM A351 CF8M Lever Ball Float Type Steam Trap Manufacturers, Check Super Duplex Ball Float Steam Trap Dimensions
As the Ball Float Steam Traps have a threshold to open the valve after the water has raised above the outlet valve, the ball opens the valve with a lever attached to the valve and the ball. The water is released. Once the water level goes below the outlet valve level, the Float Type Steam Trap ball lowers with water and the lever closes the valve. The water flow stops and the steam continues to accumulate into the chamber and to condense. The cycle repeats throughout the operation making it not necessary to manually regulate or adjust. The Carbon Steel Floating Ball Steam Trap is one of the most common in terms of the materials used for the production of these traps. Depending on the application requirements, the sizes, pressure capacities and the dimensions of the traps vary.
Table of Content
| Size | 15 & 20 |
| End connections | BSP/BSPT/NPT |
When trap is cool, the air vent opens wide for continuously discharging initial air. As cold condensate enters the trap, the float rises to allow discharge of condensate from valve port and both air and condensate from orifice. once all initial air and cold condensate have been discharged, the equipment which is connected to the steam trap reaches the operation temperature.
- PT61-4.5 : 4.5 bar
- PT61-10 : 10 bar
- PT61-14 : 14 bar
| Max. allowable pressure | 250 psig |
| Max. allowable temperature | 425 °F |
Stockist of Carbon Steel Ball Float Steam Trap Valve, Refer Duplex 2205 Ball Float Mechanical Steam Trap Price List
| Max. operating pressure | 200 psig |
| Max. operating temperature | 425 °F |
| Cold hydro test pressure | 375 psig |
ASTM A351 CF8M Lever Ball Float Type Steam Trap
Super Duplex Ball Float Steam Trap
Duplex 2205 Ball Float Mechanical Steam Trap
Carbon Steel Ball Float Steam Trap
Brass Armstrong Ball Float Trap
Cast Iron Ft14 Steam Trap
| NO. | PART | MATERIAL |
|---|---|---|
| 1 | BODY | CAST IRON IS : 210 FG20 |
| 2 | COVER | |
| 3 | GASKET (COVER) | Non CAF |
| 4 | VALVE SEAT | AISI 410/ AISI |
| 5 | VALVE | |
| 6 | LEVER | AISI 304 |
| 7 | FLOAT | AISI 304 |
| 8 | AIR VENT ASSLY. | AISI 304 |
| 9 | BOLT | HIGH TENSILE |
| 10 | DRAIN PLUG | C.S |
| 11 | GASKET DRAIN PLUG | COPPER |
| 12 | GASKET AIR VENT | COPPER |
| 13 | GASKET VALVE SEAT | COPPER |
| 14 | BRACKET ASSLY. | AISI 304 |
| 15 | LABEL | AISI 304 |
| PMA | TMA | PMO | TMO | Maximum Capacity (lbs/hr) | Size |
|---|---|---|---|---|---|
| 250 psig | 425 °F | 200 psig | 425 °F | 1090 2706 | ½”,¾”, 1” |
View Brass Armstrong Ball Float Trap Weight Chart, Leading Supplier of Cast Iron Ft14 Steam Trap
| PMO (bar) TMA (ºC) | Capacity at PMO (kg/hr) | Size |
|---|---|---|
| 14 / 220 | 482 510 | DN15, 20 DN25 |
- Design and Manufacture: GB/T12247
- Face to face(end to end): GB/T12247
- Flanged connection: GB/T 9113
- Test and inspection: GB/T 13927
- Can handle heavy condensate loads.
- Can be customized as per customer requirements.
- Float type steam traps can offer higher heat transfer rate, discharges condensate at steam temperature.
- Less susceptible than the inverted bucket trap
- Different internals are required to allow operation over varying pressure ranges
Leading ASTM A217 Grade WC6 Ball Type Steam Trap Stockholder, 316 Stainless Steel Ball Float Trap Distributor
- Heating coils
- Hot water heaters
- Steam separators
- Reactors
- Sterilizers